Evercoat Z-Grip OPTEX Premium Color Change Filler/Nikki/Bog 3.8LT with Hardener. 100382.

Description Evercoat Z-Grip OPTEX Premium Color Change Filler/Nikki/Bog 3.8LT with Hardener. 100382.       Z-GRIP® OPTEX® is an advanced clog-free, lightweight body filler with patented OPTEX Color-Changing Technology. There’s no second guessing; once mixed with cream hardener, OPTEX changes from pink to green indicating the repair is ready to sand.   Formulated for superior adhesion to galvanized steel, bare steel, and aluminum. Z-Grip OPTEX is a part of the METALWORKS® System that guarantee that the repair will maintain the O.E.M. corrosion warranty on original factory corrosion protected sheet metal and galvanized sheet metal when used in accordance with the application instructions.   Colour-changing Technology Easy Sanding Non-clog Formula Smooth Formula Applies pink and dries green   SUBTRATES: Cold Rolled Steel Aluminum SMC Galvanized Steel Fiberglass NOTE: For structural repairs prone to high degrees of stress and flexibility, use afiber reinforced filler such as Everglass®, Kitty Hair® or Fiber Tech®.     PREPARATION: Clean and degrease the entire panel to be repaired with soap and water,followed by a mild cleaning solvent. Surface must be thoroughly dry beforerepairing or applying material  Keep the repair area small. Use 80 grit to remove the paint and featheredge.   MIXING:  Stir the filler before using. Knead the cream hardener. Measure hardener 2% by weight (add a ribbon of cream hardener from edge to edge across the center of a 4” diameter puddle).  Puddles larger than 4” (10 cm) in diameter will require additional hardener. Mix thoroughly until uniform color is achieved. Approximate setting time is 5-6 minutes @ 72°F (22°C)   APPLICATION: Apply in layers with even firm pressure. Do not apply all at once. The repair will gradually change colors from pink to a light green, indicating the repair is dry and ready to sand.   FINISH: Rough shape with 80 grit Sand filler with 80 grit or finer Final sand repair and paint edge with 180 grit. NOTE: For best results, apply a premium Evercoat polyester putty to provide a smoother finish and reduce the amount of primer surfacer needed for a quality finish.     TECHNICAL SPECIFICATIONS:  Appearance Smooth Light Pink PasteVOC Refer to Section 9 of the Safety Data SheetRelative Density Refer to Section 9 of the Safety Data SheetSetting Time 5-6 minutesSand Time 20 minutesMax. Recommended Thickness (sanded) 1/4 inch (6mm) NOTE: Properties are typical values and should not be considered as sales specifications. Physical testing performed @ ~72°F (22°C) / 75% RH unless otherwise noted.   SAFETY & HANDLING: Read all directions and warnings prior to using Evercoat® products.Safety Data Sheets can be found online at evercoat.com NOTES: Never return mixed filler to can Keep can closed and store in a cool dry place USE WITH EVERCOAT® CREAM HARDENER ONLY!